Control panel design and fabrication. Installation of control equipment, instruments and alarming. Skid electrical design and layout.
Completion date: Fall of 2017
Serving the Electrical Needs of Wyoming for More Than Three Decades
Oil Field Total Flow Skids
Recent Projects
St. Anthony Tri-Parish School
70,000 square foot Pre-school through Middle school with full kitchen and cafeteria, gym, locker rooms, auditorium, chapel, classrooms and offices.
Continue reading →WYDOT – Casper Traffic Signals Communication Upgrades
General Contractor for installation of point to point wireless radio system for 55 intersections of traffic signals in Casper, WY.
Completion Date: Fall 2017
Continue reading →CDOT – Hanging Lake Tunnels – VMS, CMS, LUS Replacement
General Contractor for removal & replacement of 31 EA Variable Message Signs, & 82 EA Lane Use Signs along with control cabinets and electrical modifications for CDOT in the Hanging Lake Tunnels on I-70 near Glenwood Springs, CO.
Completion Date: Fall 2018
Continue reading →WYDOT I-90 & I-25 Interchange High Mast Lighting
General Contractor for removal and replacement of 17 EA 120’ tall High Mast Lighting poles at all interchanges of I-90 & I-25 for Buffalo, WY. Work included traffic control, drilled shaft foundations, service point upgrades, new poles & luminaries.
Completion Date: Fall 2017
Continue reading →NCSD – Kelly Walsh Football Field Sports Lighting
Subcontractor for installation of Musco sports lighting system at Kelly Walsh track & field. Work included drilled shaft foundations, conduit, 80’ steel monopole cell tower installation, wiring & luminaires.
Completion Date: Spring 2017
Continue reading →Wyoming Medical Center West Tower Addition
100,000 square feet, four story hospital entrance with new lobby, administration offices, patient rooms, as well as labor, delivery and recovery rooms and a drive-up, drop-off area.
Continue reading →Central Wyoming Regional Water System – Water Treatment Plant Generator
Subcontractor for installation of a 2 MW diesel generator. Work included duct bank, medium voltage switch gear, utility cutover, and controls wiring for backup up generator.
Completion Date: Fall 2017
Continue reading →